SparkFun Forums 

Where electronics enthusiasts find answers.

Questions about the BatchPCB service

Moderator: robacarp

By michael@dgmo.org
#3789
Give the minimum drill and pad sizes, how do I mount a SIP device that has 0.05" pin spacing? This device is not an SMD device, but 0.05" pin space seems to make it impossible to build on a board with 8 mil clearences? Any advice? (The device is the HMC1021Z magnetometer)
By michael@dgmo.org
#3895
I have absolutely no idea how the second post appeared. I only posted it once! There is no problem. :)