Stop Mask Issue

Questions about the BatchPCB service

Moderators: phalanx, robacarp

Locked
Mike187
Posts: 1
Joined: Sun Jan 13, 2013 5:12 pm

Stop Mask Issue

Post by Mike187 » Mon Jan 14, 2013 2:40 pm

I am having an issue with the stop mask. I am preparing my first board for BatchPCB and I got the common stop mask error due to the silkscreen going over pads etc. I am using the sparkfun cam and ulp files but I did not know about the sparkfun library when I made my board. I removed the silkscreen but I still have extra stop mask drawn. I do not know how to get rid of this extra stop mask. It was drawn where the silkscreen and pads etc intersected. Attached is an image showing only the tstop layer. Any help would be much appreciated.

Image

Locked