SparkFun Forums 

Where electronics enthusiasts find answers.

Questions about the BatchPCB service

Moderator: robacarp

By Scott216
#151602
I'm new to using Eagle and BatchPCB and so far I can't get my PCB to pass the BatchPCB DRC checker. Could someone post some Eagle files and the Gerber files that work with BatchPCB's DRC checker? Maybe this will help me figure out what's wrong with my files.
#151606
rf333 wrote:https://forum.sparkfun.com/viewtopic.ph ... 60#p151512
I just tried uploading the Gerber files you posted, but DRC still failed on BatchPCB.

Here's how I set the layers
Drill - drill.dri
Keep Out - all .gko files
Outline - MECH.outline
Bottom Copper - BOTTOM.gbl
Drill - DRILL.none
Top Copper - TOP.none

Also the links originally posted by ragingenferno don't work anymore. They must expire quickly.

--Scott