SparkFun Forums 

Where electronics enthusiasts find answers.

Questions about the BatchPCB service

Moderator: robacarp

#106043
The only way i can see how to get this working how we want it to set layer 2 or 15 as a normal signal layer (untick supply layer in layer properties), set the layer options in the DRC as (1*2+3*16) or (1*2+15*16) and make ground pours with the polygon tool on the layer you want.

This will make them display as normal without all this annoying "inverted-ness"... Don't know what a fab house would say about them.