SparkFun Forums 

Where electronics enthusiasts find answers.

Questions about the BatchPCB service

Moderator: robacarp

By nomad
#7773
I submitted a test board to see if it would pass, and it did :)

These are the images that it were sent back to me, do they look correct? Are the drill holes suppose to be shown?????

Thanks,
Steve

Image

Image
User avatar
By sparky
#7787
Only top and bottom copper are shown. No holes, no overlays, just stuff that might kill DRC.

-Nathan
By nomad
#7789
thanks for the replies... waited a while for the new site. Can't wait to get my first board made :) already tested my new board, and it passed :)
still waiting to decide on a few parts before I am done.

thanks