Page 1 of 1

uArm

Posted: Tue Feb 09, 2016 7:48 am
by Lucas
I just get a metallic uArm from SparkFun - as always, excellent service and punctuality.
It's really a very interesting and well developed project. However, the factory tech support is very confusing and outdated.
In order to understand the "learning mode", I had to resort to SparkFun website - though that was little outdated, at least indicated the operation of the buttons and signs. The uArm learning mode is really fantastic!
However, after run the alignment scketch (via arduino IDE), I'm finding it difficult to find the original sketch for "learning mode". I tried StandardUCP.ino and didnĀ“t work.
May be this is not the right topic in this blog...
So, I ask how should I proceed - Thanks

Re: uArm

Posted: Tue Feb 09, 2016 10:19 pm
by CaseyD-SFE
Hello!

I'm poking a member of our Tech Support team to help you out. :)