I thought it was an ad on Sparkfun...

General suggestions or questions about the SparkFun Electronics website

Moderators: phalanx, CS Paul

Post Reply
Mister chris
Posts: 4
Joined: Sun Aug 31, 2008 10:48 pm

I thought it was an ad on Sparkfun...

Post by Mister chris » Mon Feb 07, 2011 10:54 pm

I'm looking for the name of a service that helps take the breadboard portion of an Arduino project and turn it into a more professional traced board.

I thought for sure I found the link while cruising for goodies on SFE. I made the mistake of not book marking it and have been searching for it ever since. The main picture on the website was of a Submarine type vessel pumping smaller replicas of itself out of its periscope/tuba.

Does that description ring any bells?

Thanks for the help,

Chris

follower
Posts: 280
Joined: Sun Mar 14, 2010 11:58 pm

Re: I thought it was an ad on Sparkfun...

Post by follower » Mon Feb 07, 2011 11:20 pm

Lol, from the description it sounds like you're looking for Fritzing.

Good luck with your submarine. :)

--Philip;

Mister chris
Posts: 4
Joined: Sun Aug 31, 2008 10:48 pm

Re: I thought it was an ad on Sparkfun...

Post by Mister chris » Tue Feb 08, 2011 3:18 pm

Ding Ding Ding!!! Thank you Philip:D

You have no idea how much time I spent trying to find this! lol I think I've definitely learned my lesson about asking questions vs. going it on my own.

follower
Posts: 280
Joined: Sun Mar 14, 2010 11:58 pm

Re: I thought it was an ad on Sparkfun...

Post by follower » Wed Feb 09, 2011 6:27 am

Mister chris wrote:I think I've definitely learned my lesson about asking questions vs. going it on my own.
I hope that lesson was "go it alone first, then ask". :D

--Philip;

Post Reply