SparkFun Forums 

Where electronics enthusiasts find answers.

Have questions about a SparkFun product or board? This is the place to be.
#201578
D40093A9-4DF6-4B8E-992A-14DAB0F9CA33.jpeg
D40093A9-4DF6-4B8E-992A-14DAB0F9CA33.jpeg (120.9 KiB) Viewed 140 times
https://www.sparkfun.com/products/15103

I and a couple other guys have purchased the Sensirion SPS 30 Dust Particle Sensors from Sparkfun assuming the Arduino library that was linked to would be useable to get the sensor working.

I have not came across any Arduino code to get the Sensirion SPS 30 UART library working on this sensor properly like Sparkfun was able to do based on their product listing page.

Is there any way somebody at Sparkfun or any end user that has gotten this sensor working on a Arduino like device could share their code for others who are less advanced so we can put these wonderful sensors to good use?

I don’t need the i2c interface which does not supply as much data as the UART library does, the UART library is fine with me.

We have tried the linked library but no matter what we do and try it simply does not work or will not detect the sensor.

Any help getting a working library is GREATLY APPRECIATED!