- Sat Nov 24, 2018 3:04 pm
#201148
I have a Blynk Board that I have had running in the past - never used it more than for initial training. I fired it up again and reinitialized the board. After configuring, when it tries to connect to my local network, it will blink blue for a second or two, then start green and then go to a steady red. I have searched high and low on the various boards and find nothing about a steady red LED (the RGB one). It connected to both a browser and to and Android device when trying to re-configure it. Can anyone give some insight into what is going on? Is it toast?