Servo trigger switch

Have questions about a SparkFun product or board? This is the place to be.

Moderator: phalanx

Post Reply
Posts: 1
Joined: Thu Sep 13, 2018 5:12 pm

Servo trigger switch

Post by Rayray » Thu Sep 13, 2018 5:24 pm

I am new to this so please be gentle:)
I have Sparkfun servo trigger and running 9v battery so have got 5v regulator.
I know the middle & right pin is soldered to the board power out.
Question is pin 1 do i bend it back and solder positve from the 9v or do i solder to the board also?
Any actual pics of this setup would be very helpful.

Post Reply