- Wed Aug 08, 2018 2:29 am
#199974
Hi ,
Having problem with the autodriver library/board.
I have 5 boards daisy chained.
During config I write the step mode using;
I set and readback various other configuration parameters, all work correctly. It's only on step mode. Unfortunately this is a big problem since my positioning is all out of whack.
Any thoughts or things to try would be greatly appreciated.
Having problem with the autodriver library/board.
I have 5 boards daisy chained.
During config I write the step mode using;
Code: Select all
however when I read back later it returns 7 instead of 2
bdr[i].configStepMode(2); // STEP_FS_4
Code: Select all
The weird things is that it only returns incorrect result for boards 0 & 2. Boards 1,3 & 4 return correct result of 2.stepmode = brd[i].getStepMode(); // returns 7 (STEP_FS_128)
I set and readback various other configuration parameters, all work correctly. It's only on step mode. Unfortunately this is a big problem since my positioning is all out of whack.
Any thoughts or things to try would be greatly appreciated.