SparkFun Electronics Forum

In the little soundie instructions it looks like I can wire the board so I don't have to manually press the on button. My board is embedded in a project so I can't access it.

Do I wire PB to Vin? Can I leave that connected? I'm assuming yes as it worked in my testing, but I wanted to check before I burn out something if it requires a resistor or something.

Thank you!

So, my initial tests seem to be fine to tie it to Vin. However, it's making a clicking sound every 3-5 seconds which is pretty annoying. I'm guessing this may not be way it should be done.

did you ever figure this out? the button press is annoying! lol