- Mon Mar 05, 2018 11:27 am
#198563
Hi,
I would like to modify the OpenLog firmware to simplify it.
Directly record at 115200 everything it receive.
I'm trying to connect the board with the arduino IDE without success.
I've a ftdi dongle USB/232TTL converter. I cross Tx and Rx but the board is not recognize by the IDE.
Is there another tuto than the Hokkup guide that not works actually.
Thanks you
I would like to modify the OpenLog firmware to simplify it.
Directly record at 115200 everything it receive.
I'm trying to connect the board with the arduino IDE without success.
I've a ftdi dongle USB/232TTL converter. I cross Tx and Rx but the board is not recognize by the IDE.
Is there another tuto than the Hokkup guide that not works actually.
Thanks you