Page 1 of 1

Case ideas for a ESP8266 Thing - Dev Board?

Posted: Thu Dec 21, 2017 3:48 pm
by sjthespian
Has anyone found a decent case for the Thing-Dev? I have a project that is going to require me to wall-mount a couple of them and I would rather have them in a nice slim (preferably white or off-white) case. I haven't been able to turn up anything I like on-line or at any of the few remaining electronics stores in the area.

Before I go the route of trying to design something I can have 3-D printed, I figured I would see if anyone else had any ideas.