- Fri Dec 08, 2017 10:44 am
#197146
Hi Everyone,
I am trying to build out a project which involves several of these distance sensors: https://www.sparkfun.com/products/13162
I understand that you can change the I2C address by shorting out the jumper pads on the back of the board, but that will only allow me to have two different sensors on an I2C bus. Does anyone know if there is a way to "program" the I2C address on these boards?
Thanks!
I am trying to build out a project which involves several of these distance sensors: https://www.sparkfun.com/products/13162
I understand that you can change the I2C address by shorting out the jumper pads on the back of the board, but that will only allow me to have two different sensors on an I2C bus. Does anyone know if there is a way to "program" the I2C address on these boards?
Thanks!