SparkFun Forums 

Where electronics enthusiasts find answers.

Have questions about a SparkFun product or board? This is the place to be.
By alex.sneedmiller
#197146
Hi Everyone,

I am trying to build out a project which involves several of these distance sensors: https://www.sparkfun.com/products/13162

I understand that you can change the I2C address by shorting out the jumper pads on the back of the board, but that will only allow me to have two different sensors on an I2C bus. Does anyone know if there is a way to "program" the I2C address on these boards?

Thanks!
By alex.sneedmiller
#198499
I ended up just using the I2C mux and putting one sensor on each I2C bus. It would be nice if I could somehow provision the address via software to any address so that I can have more than just two sensors on one I2C bus.