OpenScale load cell combinator issue

Have questions about a SparkFun product or board? This is the place to be.

Moderators: phalanx, TS-Tim

Post Reply
blobby5
Posts: 1
Joined: Fri Nov 10, 2017 10:18 am

OpenScale load cell combinator issue

Post by blobby5 » Fri Nov 10, 2017 10:24 am

I've connected four load cells to the load cell combinator. Checking with my multimeter the ground and power on the board for each cell, there is no voltage. Serial reports "No remote sensor found".

Is there a switch that controls whether the individual load cell or combinator is used? Or have I missed something else?

Thank you

Post Reply