Third Hand kit assembly

Have questions about a SparkFun product or board? This is the place to be.

Moderator: phalanx

Post Reply
Posts: 4
Joined: Wed Jun 25, 2014 1:28 pm

Third Hand kit assembly

Post by Siddartha » Sat Sep 02, 2017 2:31 pm

I just received in the mail the Third Hand Kit that I previously ordered. However, it is not obvious to me how the alligator clips attach to the yellow ends of the flexible blue arms. I see that the 2 screws each screw into the threaded ends of the alligator clips, but I do not see how the screws then attach to the yellow ends of the blue flexible arms, and I am reluctant to try to forcefully remove the yellow ends from the blue flexible arms for fear of breaking them. When I click on the "Product Video" link at the Sparkfun Third Hand website (, no video appears even though the website says: "Note: For assembly instructions watch the product video below." I tried clicking more than once on the "Product Video" link, and each time I see "No videos found" and a blank screen. Any advice would be greatly appreciated. Thanks.

User avatar
Ross Robotics
Support Volunteer
Posts: 2007
Joined: Thu Jun 07, 2012 9:33 pm

Re: Third Hand kit assembly

Post by Ross Robotics » Sat Sep 02, 2017 9:11 pm

Available for circuit and PCB design, just PM me!

Post Reply