We tested the M6E nano module in different ranges of dBm. It started with the base input of 5dBm and it was ok until 15dBm. But when we started a trial run for a range test of 20dBm , it scanned for a split second and an error popped out saying "BAD CRC". After that the module stopped reading, we are pressing a key to begin scanning for tags at the ARDUINO serial monitor plotter but it won’t search for any tags. , we even reverted it back to 5dBm and tried plugging all the connection again but it still won't read as before.(the board is not being exposed to any static conditions since it is secured in an acrylic case)
Have questions about a SparkFun product or board? This is the place to be.
1 post • Page 1 of 1