- Tue Dec 27, 2016 5:26 pm
#192652
Whenever I try and open the serial monitor, I get the error message:
"Board at COM3 not available."
Also, when I try and upload code, I get the error message:
"Arduino: 1.8.0 (Windows 7), Board: "Arduino/Genuino Uno"
avrdude: ser_open(): can't open device "\\.\COM3": The system cannot find the file specified."
I've installed the FTDI drivers for the redboard, but the error remains. I can't find the board in device manager, or open the port in the tools section on the arduino. I'm pretty much stumped here until I can fix the issue, so any help would be appreciated.
"Board at COM3 not available."
Also, when I try and upload code, I get the error message:
"Arduino: 1.8.0 (Windows 7), Board: "Arduino/Genuino Uno"
avrdude: ser_open(): can't open device "\\.\COM3": The system cannot find the file specified."
I've installed the FTDI drivers for the redboard, but the error remains. I can't find the board in device manager, or open the port in the tools section on the arduino. I'm pretty much stumped here until I can fix the issue, so any help would be appreciated.