- Fri Jul 17, 2015 9:37 am
#183432
I just purchased a micro oled breakout board (product lcd13003) and have encountered difficulty with it. I soldered headers onto the side away from the ribbon cable. I checked the connections and they are sound. I hooked it up according to the directions on the website and downloaded the software. I compiled it with ARDUINO 1.6.4. The compiles were successful. Nothing happened. I used both an UNO (r3) and a Teensy 3.1. In neither case did I get anything on the screen. I have made no modifications to the software (I tried to run the demo and hello sketches on both platforms) and used the recommended SPI interface. Can anyone give me any suggestions?