SparkFun Electronics Forum

How do I connect "Breakout Board for Electret Microphone - BOB-09964" to Arduino Duemilanove? The BOB has AUD, VCC, GND connections. What pins on Arduino get connected to those BOB solder holes? Do I need pull up/down resistors? I didn't see a connection or wiring diagram. Maybe I overlooked it though. Please advise.

Tom

Connect the BoB GND to Arduino GND (ground), BoB Vcc to Arduino 5V and the AUD (audio out) to the analog pin that you're going to use. That's it.

Thanks Mee_n_Mac !