- Mon Aug 17, 2009 3:56 pm
#79029
Hi, I was playing with serial LCD than I´ve send a bad command, the LCD lost it´s back light than it does not receive correct characters at any baud rate :/
I´ve disabled the splat screen so the boot is too fast for sending a control r for reset, i´ve try it with no sucess
Is there any way of get this ser LCD to default values?
Tanks
I´ve disabled the splat screen so the boot is too fast for sending a control r for reset, i´ve try it with no sucess
Is there any way of get this ser LCD to default values?
Tanks