- Mon Dec 03, 2007 8:53 am
#38981
I have a Lassen iQ Evaluation Kit – USB (SKU# GPS-00165). The first time I setup the kit and tested it, everything was working according to the evaluation manual, except that I did not see any PPS output from the board.
I performed “factory reset” a few times and now when I plug in the board, none of the settings in the software (IQ_Monitor) are shown. Only the Tx light seem to be blinking. No other status changes. Is there anything I need to fix?
I performed “factory reset” a few times and now when I plug in the board, none of the settings in the software (IQ_Monitor) are shown. Only the Tx light seem to be blinking. No other status changes. Is there anything I need to fix?
