- Tue Oct 09, 2007 8:54 am
#36184
I'm sending data back and forth around a room, but when I move one of the NRF24L01's to behind a wall and change the orientation of the antenna, I stop receiveing data, or it becomes very erratic.
I notices the following setting: LNA Gain. Should this be a 1 or a 0? I see the default is 1. Which will give me more sensitivity and therefore more range? 1 or 0?
I am trying to get hold of the MAX2240 so that I can amplify the RF signal. My aim is to get about 100mW of output power. I am not in the USA. What would you recommend I use to get more power? What kind of range would the MX2240 give (estimate).
I notices the following setting: LNA Gain. Should this be a 1 or a 0? I see the default is 1. Which will give me more sensitivity and therefore more range? 1 or 0?
I am trying to get hold of the MAX2240 so that I can amplify the RF signal. My aim is to get about 100mW of output power. I am not in the USA. What would you recommend I use to get more power? What kind of range would the MX2240 give (estimate).