- Wed Sep 26, 2007 9:11 am
#35585
Hi guys.
I am testing out the GE863 module now and i connected it for testing to a Basic Stamp
This is the first time i am working with this modules and i need a bit of help understanding the commands.
Now when i turn on the device all i get is the status LED flashing (as if searching for network) but i can't seem to get anything else out of it.
Explain to me please what should the command look like if the datasheet says:
AT<cr> (Does this mean : serout pin,speed,["AT",13]?)
AT+IPR=<rate><cr> (Does this mean : serout pin,speed,["AT+IPR=9600",13]) ?
or the command: AT+CPIN=****<cr>
shoudl it look like : serout pin,speed,["AT+CPIN=1234",13] ?
Please explain to me how my data should look like and in what format should i send it.
I am testing out the GE863 module now and i connected it for testing to a Basic Stamp
This is the first time i am working with this modules and i need a bit of help understanding the commands.
Now when i turn on the device all i get is the status LED flashing (as if searching for network) but i can't seem to get anything else out of it.
Explain to me please what should the command look like if the datasheet says:
AT<cr> (Does this mean : serout pin,speed,["AT",13]?)
AT+IPR=<rate><cr> (Does this mean : serout pin,speed,["AT+IPR=9600",13]) ?
or the command: AT+CPIN=****<cr>
shoudl it look like : serout pin,speed,["AT+CPIN=1234",13] ?
Please explain to me how my data should look like and in what format should i send it.
Never stop learning!
--Dimka--
--Dimka--