- Sat Dec 02, 2006 7:04 pm
#22912
I just received my Bluetooth dongle and BlueSmirf module. After some fiddling around I got everything hooked up and talking (the light on the BlueSmirf turned from green to red, and the bluetooth software said it was paired, connected, etc.)
Problem is the smirf doesn't seem to be doing anything useful. I can't get it to respond to the +++<cr> sequence or any of the AT commands (using Hyper Terminal), and my remote device isn't able to send or receive data. I have jumpered the CTS/RTS terminals, but with a wire on the terminals, not solder.
Does anybody have an idea here? Or even a reliable way of testing the whole rig to see if it's operating properly or isolating any problems?
Any thoughts will be gratefully appreciated.
Thnaks, Bob
Problem is the smirf doesn't seem to be doing anything useful. I can't get it to respond to the +++<cr> sequence or any of the AT commands (using Hyper Terminal), and my remote device isn't able to send or receive data. I have jumpered the CTS/RTS terminals, but with a wire on the terminals, not solder.
Does anybody have an idea here? Or even a reliable way of testing the whole rig to see if it's operating properly or isolating any problems?
Any thoughts will be gratefully appreciated.
Thnaks, Bob