SAMD21 Pro RF dead after flashing

All things pertaining to wireless and RF links

Moderator: phalanx

Post Reply
Posts: 1
Joined: Sun Feb 10, 2019 12:00 pm

SAMD21 Pro RF dead after flashing

Post by maxpartenfelder » Sun Feb 10, 2019 1:11 pm

I just aquired 5 Pro RF Boards for a LoRa communication project. After plugging the boards into my Computer (Windows 10) they registered properly as COM Port devices. At some point I even made them Communicate with the sample project provided here ... okup-guide

After some tweaking and more flashing, the boards became inresponsive. They are no longer recognized as COM Port devices. This happened the same way with four of the five boards and at this point I'm afraid to plug in the last one without knowing what's going on.

I followed the steps for troubleshooting the SAMD21 Dev boards here ... leshooting but it didn't change a thing.

The code still seems to execute on the board, since the status LED illuminates shortly after startup, but the board doesn't show up in the Arduino Ports or in the Windows Device Manager.

Is there any way to do a chip erase on the Pro RF Board or to flash the bootloader again?
Why are the board failing ?

Thanks a lot

Post Reply