SparkFun Electronics Forum

Posted: **Tue Jun 19, 2018 12:15 am**

Hi,
I am using SparkFun Purpletooth Jamboree - BC127 Development Board, i want to enable AT command .I am using AT command (AT+CIND) to fetch battery and network signal strength of the connected mobile phone. Help me to resolve this issue.

Posted: **Wed Jun 20, 2018 2:08 am**

follow the instructions on : https://learn.sparkfun.com/tutorials/un ... oth-module or the datasheet. To command mode : $$$$ \r

SparkFun Electronics Forum

How to enable AT command in BC127 Bluetooth module

How to enable AT command in BC127 Bluetooth module

Re: How to enable AT command in BC127 Bluetooth module