SparkFun Forums 

Where electronics enthusiasts find answers.

All things pertaining to wireless and RF links
By mustafa404

I am trying to configure programmable xbee s2c on xbib board (smc) with an e-paper display. The epaper display requires a RAM of around 6kb on the micro controller chip which could load the the framesize of the epaper display.

Well according to the datasheet on the digi website ( it shows that the RAM is 2kb and flash memory is 32kb on the programmable chip which means it is not enough BUT on silicon lab website ( ... /EM35x.pdf) it mentions that the em357 chips installed on xbee have 12kb RAM and 128kb Flash memory. It is a bit confusing.

Xbee Part no. XB24CZ7UISB003-REV

Can someone verify which one is correct or am i interpreting this incorrectly.

By Valen
Seems like is the place with the most reliable answer. That datasheet says it is "based on" the em357 chip. Maybe they use a customized reduced ram version.