- Fri Feb 12, 2016 1:48 pm
#188098
So after figuring out that GPIO pin 0 needed to be grounded tp program the "Thing" I attempted the simple Blync tutorial and the thing ain't working.
The COM serial port from the arduino IDE won't do anything at all unless I connect the sleep jumper which I soldered on. Then is spits out two things depending on GPIO 0's grounding
Without:
ets Jan 8 2013,rst cause:2, boot mode:(3,7)
load 0x4010f000, len 1264, room 16
tail 0
chksum 0x42
csum 0x42
~ld
And when I ground it the boot mode problem is (1,7)
If the sleep jumper is removed... Nothing happens. No serial out period.
Internet says:
reset causes:
0:
1: normal boot
2: reset pin
3: software reset
4: watchdog reset
boot device:
0:
1: ram
3: flash
What in Gods name do I have to do to get this "Thing" working or is this just not w working board
Thanks
The COM serial port from the arduino IDE won't do anything at all unless I connect the sleep jumper which I soldered on. Then is spits out two things depending on GPIO 0's grounding
Without:
ets Jan 8 2013,rst cause:2, boot mode:(3,7)
load 0x4010f000, len 1264, room 16
tail 0
chksum 0x42
csum 0x42
~ld
And when I ground it the boot mode problem is (1,7)
If the sleep jumper is removed... Nothing happens. No serial out period.
Internet says:
reset causes:
0:
1: normal boot
2: reset pin
3: software reset
4: watchdog reset
boot device:
0:
1: ram
3: flash
What in Gods name do I have to do to get this "Thing" working or is this just not w working board
Thanks