- Wed Nov 25, 2015 1:05 am
#186162
Hello,
I have a running project using the RedBoard and the ESP8266 WiFi shield...
These are the steps:
1. Connect to the shield via (soft)serial
2. Connect the access point
3. send POST messages to some server
All these works perfectly...for 2-3 hours, but then POST messages are stop to reaching the server...
Adding some debug messages I found that the local IP address of the WiFi shield got corrupted (in normal it is like 10.0.0.x, but it becomes x.0.0.0, where x changes every few seconds)...To add this the connection to the access point still seems to be intact from both end...
I tried to restart and also unplug the module, but it have to be off for a long time (more than half hour) before comes back to normal functionality...
Anybody with some experience about such problem?
I have a running project using the RedBoard and the ESP8266 WiFi shield...
These are the steps:
1. Connect to the shield via (soft)serial
2. Connect the access point
3. send POST messages to some server
All these works perfectly...for 2-3 hours, but then POST messages are stop to reaching the server...
Adding some debug messages I found that the local IP address of the WiFi shield got corrupted (in normal it is like 10.0.0.x, but it becomes x.0.0.0, where x changes every few seconds)...To add this the connection to the access point still seems to be intact from both end...
I tried to restart and also unplug the module, but it have to be off for a long time (more than half hour) before comes back to normal functionality...
Anybody with some experience about such problem?