Help with a simple simple servo-motor project?
Posted: Mon Dec 01, 2014 5:26 pm
I'm new to all of this. I'd like to find a plug/play solution to a dead simple need.
I need to adjust a dial (usually rotated by fingertip) on a machine that delivers air from 0 to 10L/min , remotely, RF preferably, with a small hand-held remote that would ideally have a single dial on its face. No more.
The remote radio dial emulates the rotation of the servo driven knob on the machine. Clockwise and counter. The driven knob/dial rotates approx 270 degrees. Torque requirements are low... in the range expected of a finger turned knob on a stereo volume control (for instance).
Any suggestions?
I need to adjust a dial (usually rotated by fingertip) on a machine that delivers air from 0 to 10L/min , remotely, RF preferably, with a small hand-held remote that would ideally have a single dial on its face. No more.
The remote radio dial emulates the rotation of the servo driven knob on the machine. Clockwise and counter. The driven knob/dial rotates approx 270 degrees. Torque requirements are low... in the range expected of a finger turned knob on a stereo volume control (for instance).
Any suggestions?