- Fri Apr 14, 2006 1:02 pm
#12308
Okay, so I hope this isn't a really obvious and stupid question. Basically, I have noticed that everytime a bluetooth connection is initiated, you get a CONNECT,<device-address> message sent down the tx line. Then you can pipe data like you would expect, and when the connection is closed a "NO CARRIER" message is sent.
Only reason I noticed this is because I hooked it up to a TTL converter and am piping data back into my computer. Now, this is an issue forme because I am trying to tie it into one of pololu's micro servo controllers, and it says it is a system error when it gets data it isn't expecting.
Anyway I can make this sucker go silent? I've been through the docs, but nothing has jumped out at me yet.
Thanks in advance,
-Jay
Only reason I noticed this is because I hooked it up to a TTL converter and am piping data back into my computer. Now, this is an issue forme because I am trying to tie it into one of pololu's micro servo controllers, and it says it is a system error when it gets data it isn't expecting.
Anyway I can make this sucker go silent? I've been through the docs, but nothing has jumped out at me yet.
Thanks in advance,
-Jay