- Thu May 01, 2008 9:00 pm
#47475
hello dear sparkfun folks,
i'm a newbie ;)
i've got a FT232RL USB to Serial breakout board i'm trying to figure out how to self power... appears i need to pull the reset low, but i'm not entirely clear where that is on the board.
does anyone have any ideas?
i'm a newbie ;)
i've got a FT232RL USB to Serial breakout board i'm trying to figure out how to self power... appears i need to pull the reset low, but i'm not entirely clear where that is on the board.
does anyone have any ideas?