- Tue Apr 08, 2008 5:21 am
#46014
I have the Bluetooth DIL module, and am connecting it to the console port of my Hammer Board. Is it necessary to cross the RX and TX lines between the two, or does the BT module do that itself? I already figured out I have to jumper RTS and CTS, but am still not quite sure this is correct. So far, Hammer will boot if the module is not in its socket, and I get full console I/O. However, if the module is in it's socket, Hammer boots and I get no transmission to it. I get out put from Hammer but can not send anything to it.
Any ideas?
8-Dale
Any ideas?
8-Dale
[url=http://www.thedynaplex.org]The Dynaplex Network[/url] - Linux, Robotics, and Open Source
[url=http://www.gentoo.org/]Kubuntu[/url] is my current Linux distribution. 73 from N7PKT!
[url=http://www.gentoo.org/]Kubuntu[/url] is my current Linux distribution. 73 from N7PKT!