SparkFun Forums 

Where electronics enthusiasts find answers.

By PhilHays
#202187
I'm going to need to debug a processor in an FPGA without access to pins for attaching a JTAG dongle to.

Xilinx has an AXI4-Lite to JTAG core available. See:

https://www.xilinx.com/support/document ... alinux.pdf

I'd just be using the AXI2JTAG core, and not the "Virtual Cable" software. This is on a Xilinx FPGA, and is using a non-Xilinx supported soft processor core. The axi2JTAG core would be accessed over PCIE as a set of registers.

Has someone done this before?

Is it reasonable to write the configuration file needed? Examples of something similar, documentation?