SparkFun Forums 

Where electronics enthusiasts find answers.

Hi Everyone,

I want to program xmc1301 16 pin TSSOP package by use of OpenOCD and J-link EDU mini

I configure following steps correctly:
--> install perfectly OpenOCD to windows7
--> install msys32 successfully
--> interface xmc1301 chip with j-link EDU mini as below:
P0.14[SWDIO0] with SWDIO of J-link
P0.15[SWDCLK] with SWCLK of J-link
GND[Vss] with GND[pin3] of J-link
Vcc[3.3V] with Vtref of J-link(3.3V externally supply voltage)

now I got correctly OpenOcd J-link SWD transport connection of XMC1301
My Actual problem that "Unable to reset target --> and as I know in SWD method don't need to target reset pin"
error images as:

Please respond fast if anyone have solution of this issue...

Thanks in advance..