- Thu Dec 29, 2011 4:17 am
#137551
Hi
I am trying to connect my Olimex-Arm-USB-OCD(http://www.sparkfun.com/products/7834) to my stm32F1 board(http://www.sparkfun.com/products/8559) through crossworks.
When i goto target-->Connect-->Olimex-ARM-USB_OCD, i get the following error message
"Cannot identify target, please check jtag connections and try again".
Both boards are powered from the usb ports on my computer. So i wouldn't
suspect power.
What's going wrong?
Are my drivers for Olimex-ARM-USB-OCD installed correctly, in windows. After driver installation, it appears as a usb serial port.
Thanks
S
I am trying to connect my Olimex-Arm-USB-OCD(http://www.sparkfun.com/products/7834) to my stm32F1 board(http://www.sparkfun.com/products/8559) through crossworks.
When i goto target-->Connect-->Olimex-ARM-USB_OCD, i get the following error message
"Cannot identify target, please check jtag connections and try again".
Both boards are powered from the usb ports on my computer. So i wouldn't
suspect power.
What's going wrong?
Are my drivers for Olimex-ARM-USB-OCD installed correctly, in windows. After driver installation, it appears as a usb serial port.
Thanks
S