SparkFun Forums 

Where electronics enthusiasts find answers.

Search found 6 matches

 Go to advanced search

I already did that

 by zouze ¦  Mon Jul 13, 2009 12:36 am ¦  Forum: SparkFun Product Questions ¦  Topic: How to use PIR sensor? ¦  Replies: 25 ¦  Views: 5673

and it does not work either.

 by zouze ¦  Sun Jul 12, 2009 8:58 pm ¦  Forum: SparkFun Product Questions ¦  Topic: How to use PIR sensor? ¦  Replies: 25 ¦  Views: 5673

You want the resistor and diode to be in series. The resistor connects to 5v and the cathode of the diode to the Black wire. You will want reduce the value of the resistor to around 470 ohms if you want the LED to be brighter. Leave the 10k resistor connected to the anode of the diode, but don't co...

I also could not make it work

 by zouze ¦  Sun Jul 12, 2009 12:26 am ¦  Forum: SparkFun Product Questions ¦  Topic: How to use PIR sensor? ¦  Replies: 25 ¦  Views: 5673

here is the circuit:
Image
can you tell me what's wrong with it?

 by zouze ¦  Sun Jul 12, 2009 12:09 am ¦  Forum: SparkFun Product Questions ¦  Topic: PIR Sensor..Can'g get it to work.. ¦  Replies: 2 ¦  Views: 1505

I could not also make it work...I am experiencing the same thing...but I have interfaced it with an at89c2051...then I removed it and put a led at the alarm pin with 10k pull up resistor but still it does not work here is the circuit I am using which I could not make to work properly: http://img268....

The Note

 by zouze ¦  Mon Jun 01, 2009 1:54 am ¦  Forum: SparkFun Site Questions/Comments ¦  Topic: Nokia breakout: inductor very hot ¦  Replies: 16 ¦  Views: 11858

There is note that says, Pins 8 and 9 on the Nokia LCD connector will be connected with a solder bridge. Have you done this? Can you tell me how to do this?

Color LCD Breakout Board

 by zouze ¦  Mon Jun 01, 2009 1:51 am ¦  Forum: SparkFun Site Questions/Comments ¦  Topic: Color LCD Breakout Board ¦  Replies: 0 ¦  Views: 603

Hi, I just bought the Color LCD Breakout Board https://www.sparkfun.com/commerce/product_info.php?products_id=8600 I noticed that there is a note that says: "Pins 8 and 9 on the Nokia LCD connector will be connected with a solder bridge." What does this means? Pls show how. Is this breakout board re...